|
S&F Inc
(Homepage) |
2007-09-01 15:02:02, 조회 : 1,271, 추천 : 97 |
Robo Splint
2-1. The upper non-woven to easily suck water
The upper cover of ROBO™ Splint apply the non-woven to easily suck water. The polyurethane resign in inner fabric material be reacted by the only minimum water. ROBO™ Splint will set in approximately 3-5 minutes and be weight-bearing in approximately 20-30 minutes. Therefore, Minimum water needed to activate ; pour or spray water on the upper cover and apply.
2-2. The lower non-woven cover to make watertight
ROBO™ Splint provide patient good hygienic conditions and comfort as use a watertight non-woven cover on the affected part of patient.
2-3. Better Ventilation
ROBO™ Splint provide patient good hygienic conditions and comfort as use well ventilated fabric material
2-4. The clean cutting plane
Roll Type of ROBO™ Splint have a very clean cutting plane. It have not project stings as the kinds of needles into the cutting plane. therefore, The patients security from scratch on their skin, and It is not happened to injure their clothes.
2-5. Environmentally friendly
Substrate can be burned up after use, without burying the used things in the ground.
|
|
|
